haier 16 - Manual (Page 9)

Dismantling
1. Fix refrigerator and freezer door by sticking adhesive tape on both sides to hold
doors in place.
2. As shown in fig. 1, remove hinge top cover on the upper part of freezer door.
Then remove the two screws from the hinge. Take out the hinge by pulling it verti-
cally, and keep it in a safe place.
3. Remove the adhesive tape on freezer door, lift and take the door down, and
carefully put it aside.
4. As shown in fig. 2, remove screws of the central hinge, lift and take down the
central hinge and pad, and keep them in a safe place.
5. Remove the adhesive tape on refrigerator door, lift and take down
refrigerator door, and carefully put it aside.
Reinstallation
1. As shown in fig 3 remove the door axle and
install on the opposite hole with washer pads
(2) in place. Now dismantle the lower hinge
and install the opposite side with the hinge
spacer and washer pads in place.
2. Install refrigerator door: make the left bottom
hole of the refrigerator compartment door fall
over the lower hinge axle, move the door back and forth to make it straight
and in alignment with central hinge. Install the central hinge again, turn the
hinge axle until it completely enters the door body, then fix it with screws.
3. Install freezer door: align left bottom hole of freezer door over the central
axle. Take hinge and adjust so that hinge axle can be installed in the upper
hole of the freezer door; adjust door to make it straight and level. Tighten
the screws of upper hinge.
4. Install top hinge cover on the left side.
8
English
washer
pads (2)
bottom hinge
door axle
bottom hinge
spacer
bottom hinge
fig. 4
central
hinge axle
central hinge pad
fig. 2
central hinge axle
central hinge pad
fig. 3
English