haier HWM110-23BS - Manual (Page 11)

9
Washing sequence
Figure 3
Figure 4
Figure 5
Spin timer Wash timer Wash selector
(To set to below 2 minute,
first set to 5 minute then
turn it back. It can increase
the service life of the timer).
(standard current,
strong current)
(To set to below 1 minute,
first set to 2 minute then
turn it back. It can increase
the service life of the timer).
Water-filling selector
Wash
1.Water-filling selector
Set the water inlet selector at the "WASH" side.
(Figure 1)
2. Fill the water and add the dissolved washing
powder to make the water level reach the preset
position. (Figure 2)
Run washing program for some time to stir and
dissolve the powder completely.
3.Put in the laundries. If the water quantity is
insufficient, please add water.
4.Select the current.
Select the strength of the current according to
the laundries. (Figure 3)
5.Select the washing time
Select the washing time according to the laundries.
(Figure 4)
6.After washing, Set the "WASH SELECTOR" at
"DRAIN" in order to discharge the water. (Figure 5).
Water inlet
entrance
5
3
1
2
4
9
15
12
6
3
OFF OFF
Figure 1
SPIN WASH
Figure 2
9
15
12
6
3
OFF