Hoover FloorMate Floor Mate SpinScrub Hard Floor Cleaner with portable tool kit - Manual (Page 8)

8
17
The Mode selector dial (A) turns the brush-
es on and off.
Your HOOVER FloorMate™ SpinScrub™ Cleaner can be used to both vacuum dry debris
and wet clean non-carpeted floor surfaces such as vinyl, tile, marble and sealed wood. It is
not intended for use on carpet or rugs.
CAUTION: To prevent damage to wood floors, follow the flooring manufacturer’s clean-
ing recommendations.
If using cleaner on sealed wood floors, inspect floor surface for worn finish, bare wood or
separated joints. Do not use FloorMate™ SpinScrub™ Cleaner to wet clean sealed wood
floors if any of these conditions exist.
General operation
Mode selector dial
For dry debris pickup, turn the dial to the
DRY VAC position. In this position, the
brushes will not rotate and are raised off the
floor surface.
To wet clean with brushes turned ON, turn the
dial to the WASH position.
For wet pickup, turn the dial to the WET PICK-
UP position.
Refer to “How to clean” section for complete
cleaning instructions.
To move your cleaner from room to
room, put handle in upright posi-
tion, tilt cleaner back on rear wheels
and push forward.
Transporting 15
16
The cleaner may also be lifted using the car-
rying handle (A) on the front of the cleaner.
A
15
16
17
18
18
A