Ballast assembly replacement instructions, Lamp socket, Ballast ignitor – Heath Zenith SL-5679 User Manual

Page 2

Advertising
background image

2

598-1235-01

Lamp

Socket

Photocell

Socket

Ballast

Ignitor

Red

Red

Red

Blac

k

Blac

k

Blue

Blue

White

White

White

Blac

k

White

Blac

k

120V AC

Input

Ballast Assembly Replacement Instructions

1. Remove plastic cover.
2. Remove bulb.
3. Remove five screws attaching reflector to fixture housing.
4. Label wires according to wiring diagram.
5. Remove wire nuts from wires. Retain wire nuts to connect replacement

ballast assembly.

6. Remove two screws and lock washers holding ignitor and ballast in

place.

Ballast assembly can be replaced without the
cutting of any wires. Use of a qualified electrician is
recommended.

Fixture Housing

Ballast

Ignitor

Ignitor Retention Screw

7. Dispose of used ballast assembly.
8. Connect the replacement ballast assembly following steps 1

through 7 in reverse order.

CAUTION: Ballast is held in place by ignitor. Carefully
remove the ignitor and the ballast together to avoid
personal injury in case the ballast slides out of unit.

Lock Washer

Reflector

Reflector Screw (x5)

WARNING: Turn power off at the fuse or circuit

breaker.

Advertising