Haan FS-30P+ - Manual (Page 26)

Troubleshooting
(cont)
PRoBLeM: Water is leaking from the Pet Plus ™ .
Possible Cause:
1) Your unit’s Water Tank is overfilled.
Possible Solution:
1) The fill line on the Fill Cup indicates the proper
amount of water needed for the tank, but you may
want to try putting a little less water in the tank.
IMPORTANT NOTE: Water should not go above the
level indicator “bar” inside the opening on top of the tank.
PRoBLeM: Pet Plus ™ leaves water on the floor.
Possible Cause:
1) Cleaning pad is saturated.
2) Unit is not level on the floor.
Possible Solution:
1) Turn off unit, unplug from power outlet and change
the cleaning pad as described on pg 10-11.
2) Always keep the Pet Plus ™ level and parallel
to the floor.
PRoBLeM: Pet Plus ™ left white spot on the floor.
Possible Cause:
1) The Pet Plus ™ left in one spot for too long.
2) The Pet Plus ™ was not placed on the Floor
Protector/Resting Mat.
3) Hard water was used in the Pet Plus ™ .
Possible Solution:
1) Always place your Pet Plus ™ on the Floor Protector/
Resting Mat whenever not actively using it. Never
leave the Pet Plus ™ in one spot on any surface for any
period of time.
2) Use distilled water in the Pet Plus ™ .
NOTE: To remove the spot, use a damp, dry cloth
with a few drops of white vinegar and rub the
stain to remove spot.
pg 24 877-HAAN DIRECT / 877-422-6347 www. HAANUSA.com