Honeywell HXMT9 / HXMT9X - Manual (Page 85)

Appendix A
Troubleshooting
Problem Try This
No Video (black screen) Check power connections
No Video (one camera) Check camera power and coaxial cable
No Video (jumbled colors) Make certain multiplexer is set correctly for
your system (EIA or CCIR)
Fuzzy Image (one camera) Check camera focus
Bad Video (one camera) Check the loop through connector.
If a cable is attached, make certain it is
connected to another video device on the
other end.
Wrong Language Change the language in the Setup Menu
Buttons Locked Unlock buttons in Setup Menu.
Recorded Video Rolls Check VCR configuration in Setup Menu.
Use the trigger pulse from the multiplexer
for optimum synchronization with a time-
lapse VCR.
Tape Plays Only 3x3 Make certain video cable to the VCR input
is connected to the VCR OUT of the
multiplexer.
Too Many Motion Alarms Adjust sensitivity of motion detection grid.
Adjust size of grid required to activate
motion alarm. Make certain only the area
you want to detect motion is activated.
Motion Not Detected Adjust sensitivity of motion detection grid.
Adjust size of grid required to activate
motion alarm.
Make certain the area you want to detect
motion is activated.
71
ENGLISH