haier DD400RS - Manual (Page 9)

8
English
How to use this product
Important Notes Before You Connect the Power Supply
Actual power supply should be kept in accordance with marks on rating
plate(115V/60HZ). Rating plate is on back of unit.
Power socket should be equiped with fuse of 10A. Allow the unit to sit on its
base for at lease one hour before installation.
CAUTION: DON'T USE EXTENSION CORDS
Connect the power supply
Unit is tested and set to be 38ºF before leaving the factory. When connected
with the power supply, unit will work properly.
Interior LED bulb:
LED bulb is located on top of interior liner in each upper and lower
compartment. It is controlled by drawer opening and closings: when drawer
is open, it’s on, when drawer is closed, it’s off. .
Caution: There are magnets that are affixed on left side of interior upper
drawer and bottom of lower drawer door. Don’t remove them as they are
required for proper functioning of the light system.
Temperature setting:
If you want to change temperature, press “SET” for three seconds, the unit
will beep, temperature will flash in control panel, then you can adjust the
figure using the “ ” and “ ” buttons. When desired temperature is set, press
the “SET” button again to confirm your setting. The user will hear a beep and
the temperature will no longer flash.
If you want to lower the temperature, press the " " button.
If you want to raise the temperature, press the " " button.
Drawers
Upper Drawer
Can hold any item under 12 inches tall.
Lower Drawer
Lower drawer is separated by step. Foods or beverage whose height is less
than 12 inches can be kept in the space without step. Smaller items can be
kept in space with step.
Temperature range is : 34-45ºF (1-7ºC)