Hitachi 50UX58K - Manual (Page 30)

SET UP - 30 -
Press EXIT to quit MENU or CURSOR to return to previous menu.
Reception channels for each mode are shown at the left.
Refer to your cable or TV guide for channel identification standards.
If certain CATV channels are poor or not possible in CATV1 mode, set SIGNAL SOURCE to CATV2.
AUTO CHANNEL SET
This feature will automatically store active TV channels in CHANNEL MEMORY. This will allow you to skip over
unused channels when using CHANNEL UP ( ) or DOWN ( ) buttons.
Auto Channel Set Menu
If the EXIT button is pressed while the AUTO CHANNEL SET function is engaged, programming will stop. If two
antennas are connected, switch antenna inputs with the INPUT button and repeat AUTO CHANNEL SET for the
second antenna input.
Remember to select the correct SIGNAL SOURCE mode before using AUTO CHANNEL SET for the second
antenna input.
See CHANNEL MEMORY to add or erase additional channels.
CHANNEL MEMORY
Use this function after AUTO CHANNEL SET to add or erase additional channels to the remote control CHANNEL
or buttons.
Channel Memory Menu
Add or erase additional channels while still in CHANNEL MEMORY using CURSOR or or the number
buttons to change the channel.
Press EXIT to quit menu or CURSOR to return to previous menu.
CHANNEL LIST
This function allows you to review which channels are labeled in CHANNEL ID (ID.) which have been added to
CHANNEL MEMORY (SCAN), and which are protected by CHILD LOCK (LOCK).
Channel List Menu
Press CURSOR or to review more channels.
Press EXIT to quit menu or CURSOR to return to previous menu.
NOTE: Each touch of CURSOR or will scan to the next eight channels.
CLOCK SET