Hitachi 42V525 - Manual (Page 4)

ACCESSORIES
4
1. Remote Control Unit CLU-4341UG2 (Part No. HL02071) or Remote Control Unit CLU-4351UG2 (Part No. HL02072).
2. Two “AA” size, 1.5V batteries (For Remote Control Unit).
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
1. Open the battery cover of the remote control by pushing the notched part of the cover with your fingers and pulling the
cover off.
2. Insert two new “AA” size batteries for the remote control. When replacing old batteries, push them towards the springs
and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery compartment.
4. Replace the cover.
BOTTOM VIEW
Lift up on tab to
remove back cover.
(Remote Control)
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace with the same or equivalent type.
Check to make sure you have the following accessories before disposing of the packing material.
1. 2.
REMOTE CONTROL BATTERIES
(“AA”)
OPTIONAL LCD STAND
LCD STAND: SP42WB
PART NO: QJO1542
FIRST TIME
USE
CAUTION: This SP42WB LCD stand for use only with Hitachi 42V525. Use with other apparatus is capable
of resulting in instability causing possible injury.