Hearth and Home Technologies Multifunction Wall Control WSK300 - Manual (Page 12)

Wall Control - WSK300
Control Specifi cations
12
/&& 4(%2-/34!4 /.
0),/4 4)-%2
-/$%
&
#

3%4
6%.4
2
&,!-%
&! .
/&&
-).
0),/4
!58
Press MODE to set
THERMOSTAT
SET ROOM TEMP
will display
&
#

3%4 2//-
6%.4
2
&,!-%
&! .
/&&
-).
0),/4
&
#

3%4
6%.4
2
&,!-%
&! .
/&&
-).
0),/4
• Press button until
THERMOSTAT setting is
highlighted.
• In THERMOSTAT mode,
SET ROOM TEMP icon
is highlighted. This func-
tion will maintain room
temperature based on
desired setting.
-/$%
Function - ROOM TEMPERATURE settings
&
#

3%4 2//-
6%.4
2
&,!-%
&! .
/&&
-).
0),/4
&
#

3%4 2//-
6%.4
2
&,!-%
&! .
/&&
-).
0),/4
Press UP or
DOWN arrow but-
tons to determine
desired setting
Wall Control
THERMOSTAT mode will automatically
adjust fi replace Flame Size and Fan
Speed based on the desired room
temperature. If AUX 1 (Fan) is pressed
AUT will display on the screen.
(When the control is fi rst powered,
the THERMOSTAT mode will gather
room temperature information for 4
minutes before it will begin to operate
-after 4 minutes of having power
THERMOSTAT mode will initiate
immediately when selected).
• Press settings within
three seconds to adjust.
• Press UP arrow to
increase ROOM TEMP,
in 1 degree increments,
to a maximum of 90º F.
• Press DOWN arrow to
decrease ROOM TEMP,
in 1 degree decrements,
to a minimum of 55º F.
• Once the desired ROOM
TEMP is set, continuous
display mode will be displayed
after three seconds.
• In THERMOSTAT mode, to
change ROOM TEMP again,
press buttons to desired
setting.