Caution, Peel and apply labels as shown – Hasbro Adventure Bob's Construction Site 6601 User Manual

Page 2

Advertising
background image

5.

CRANE

•

Snap crane onto tower.

1.

TOWER

•

Align tabs and posts on tower

with slots and holes in seat.

Snap tower into place.

•

Tighten 4 screws through

underside of seat to secure

tower to seat.

•

Insert drainpipe through slot

and into hole under tower

roof. Be sure bottom end of

drainpipe is inserted into

round flange on seat.

CAUTION:

TO

AVOID BATTERY LEAKAGE

1)

Be sure to insert the batteries correctly
and always follow the toy and battery
manufacturers’ instructions;

2)

Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries;

3)

Always remove weak or dead batteries from the product.

Use a Phillips screwdriver to loosen screw in
battery compartment door (screw remains
attached to door). Remove door. Insert 2 fresh
"AA" alkaline batteries as indicated. Replace
door and tighten screw.

BATTERY INSTALLATION

ASSEMBLY

3.

HOUSE

•

Slide elevator connector onto

side rail on house.

Be sure to

do this before installing

house

.

•

Align lip on house with

inside square on seat, and

align side rail on house with

side rail on tower. Snap

house into place.

Tower

Drainpipe

Seat

2.

LIFT

•

Align lip and squares on

lift with slots and squares

on underside of seat, and

snap lift into place.

4.

WORKSHOP

•

Align lip on workshop with

square on seat, and snap

workshop onto seat.

•

Fit workshop door onto

workshop (bumps into holes).

7.

HOUSE DOOR, ELEVATOR, WINDOW

8.

LIFT BUCKET & TRAP DOOR

Peel and apply labels as shown.

Workshop

Workshop

Door

Crane

Large

Window

Scaffolding

Board

•

Fit large window into area

above workshop door.

•

Fit posts on scaffolding board into holes on the side of the large

window. (Fit board into any of the 3 sets of holes.)

•

Insert bottom bump on house door into bottom hole in house

doorway, then snap top bump into top recess on house doorway.

•

Slide tabs on elevator

connector into grooves on

elevator to attach elevator.

•

Fit elevator door onto

elevator (bumps into

holes).

•

Fit small window into area

above top of door.

•

Fit roof onto bottom of

crane tower.

6.

WORKSHOP DOOR, WINDOW, SCAFFOLDING BOARD

LABEL PLACEMENT

Elevator

Door

Elevator

Small

Window

Roof

Trap Door

Door

House

Lift

Elevator

Connector

Lift

Bucket

•

Fit lift bucket onto lift

bracket (bumps into holes).

•

Fit trap door onto seat

(bumps into holes).

Round

flange

Slot

Advertising