Maintenance – Husqvarna CT20 User Manual

Page 18

Advertising
background image

MAINTENANCE

18

MS−3615MA

LUBRICATION

Every 25 hours and/or at the beginning of

each season, make sure the gear box is

filled with lubricant (see Figure 10). Tubes of

gear lubricant are available from most auto-

motive supply stores. Use portable tool

grease such as Lubriplate 630AA (Product

No. 06787, 1−3/4 oz. tube) or Lubriplate

GR−132 (Product No. 15892, 10 oz. tube).
After cleaning and before storage, apply oil

to the tine shaft (see Figure 10).

WARNING: Allow the transmis-

sion to cool before filling with

grease.

1. Remove both left side tines. See “How

To Replace The Tines” in the Service

and Adjustments section.

2. Remove the air vent screw (see

Figure 10).

3. Mount a grease gun onto the grease fit-

ting. Fill the transmission until the

grease begins to come out of the air vent

screw hole.

4. Reinstall the air vent screw.
5. Check the condition of the felt washer

(see Figure 10). Replace the felt wash-

er if it is damaged (see the Repair Parts

section in this manual).

6. Clean and lubricate the tine shaft with a

few drops of oil.

7. Reinstall the left side tines.
8. Remove the right side tines. Check the

felt washer for damage. Clean and oil

the tine shaft. Reinstall the right side

tines.

Figure 10

Grease Fitting

Tine

Shaft

Air Vent Screw

Felt

Washer

HOW TO CLEAN THE TINES

Always remove dirt and debris from the culti-

vator after each use. Remove any string,

wire or vegetation that may become lodged

in the mechanism and stop the tines from

rotating.
1. Release the throttle control and move

the on−off switch to the OFF position.

Disconnect the spark plug wire from the

spark plug.

2. While wearing gloves, remove the latch

pins that secure the tine assemblies to

the shaft (see Figure 11). Remove the

tines from the shaft.

3. Remove any lodged debris from the

shaft and tines. Clean and lubricate the

tine shaft with a few drops of oil.

4. Reassemble the tines on the shaft and

secure with the latch pins.

5. Connect the spark plug wire to the spark

plug.

Figure 11

Tine

Latch Pin

.

Advertising