Harbor Freight Tools Metal Cutting Bandsaw 97099 - Manual (Page 11)

Page 11 SKU 97009 For technical questions, please call 1-800-444-3353.
UNpACkING
When unpacking, check to make sure that the item is intact and undamaged. If
any parts are missing or broken, please call Harbor Freight Tools at the number shown
on the cover of this manual as soon as possible.
SET Up INSTrUCTIONS
read the ENTIrE IMpOrTANT SAFETY INFOrMATION section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
risk of accidental starting; resulting in serious personal
injury. Turn the power Switch of the tool to its “OFF”
position and unplug the tool from its electrical outlet before
assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagrams near the end of this manual.
Assembly
NOTE: To assemble and locate the Bandsaw will require additional assistance
and a proper lifting device.
After the Bandsaw and its accessories are unpacked, make sure its Head is
lowered to its horizontal position. (See Figure A.)
With a proper lifting device, raise the Bandsaw approximately six inches off the
floor surface. (See Figure A.)
FIGUrE A
Once the Bandsaw is lifted, insert the Wheel Rod (92-4) through the two holes
located at the bottom/right side of the Stand (77S). Slide one Wheel (92-2) on
each end of the Wheel Rod. Place one Washer (92-1) on each end of the Wheel
1.
2.
3.
4.
WArNING WArNING