Installing the water line, Installation instructions, Connect the tubing to the valve – Hotpoint 19 User Manual

Page 16: Flush out the tubing, Cont.), Fasten the shutoff valve, Tighten the pipe clamp, Route the tubing

Advertising
background image

Place the compression nut and ferrule (sleeve)
for copper tubing onto the end of the tubing and
connect it to the shutoff valve.

Make sure the tubing is fully inserted into the valve.
Tighten the compression nut securely.

For plastic tubing from a GE SmartConnect

Refrigerator Tubing kit, insert the molded end
of the tubing into the shutoff valve and tighten
compression nut until it is hand-tight; then tighten
one additional turn with a wrench. Overtightening
may cause leaks.

NOTE:

Commonwealth of Massachusetts Plumbing

Codes 248CMR shall be adhered to. Saddle valves
are illegal and use is not permitted in Massachusetts.
Consult with your licensed plumber.

CONNECT THE TUBING TO THE
VALVE

7

Turn the main water supply on and flush out the
tubing until the water is clear.

Shut the water off at the water valve after about
one quart (1 liter) of water has been flushed
through the tubing.

FLUSH OUT THE TUBING

8

INSTALLING THE WATER LINE

(CONT.)

Installation Instructions

16

Saddle-Type
Shutoff Valve

Compression
Nut

SmartConnect

Tubing

Packing Nut

Outlet Valve

Ferrule (sleeve)

Fasten the shutoff valve to the cold water pipe with
the pipe clamp.

NOTE:

Commonwealth of Massachusetts Plumbing

Codes 248CMR shall be adhered to. Saddle valves
are illegal and use is not permitted in Massachusetts.
Consult with your licensed plumber.

FASTEN THE SHUTOFF VALVE

4

Tighten the clamp screws until the sealing washer
begins to swell.

NOTE:

Do not overtighten or you may crush the

tubing.

TIGHTEN THE PIPE CLAMP

5

Route the tubing between the cold water line and
the refrigerator.

Route the tubing through a hole drilled in the wall

or floor (behind the refrigerator or adjacent base
cabinet) as close to the wall as possible.

NOTE:

Be sure there is sufficient extra tubing

(about 8

′ [2.4 m] coiled into 3 turns of about 10″

[25 cm] diameter) to allow the refrigerator to move
out from the wall after installation.

ROUTE THE TUBING

6

Washer

Inlet End

Pipe Clamp

Clamp Screw

Vertical Cold
Water Pipe

Saddle-Type
Shutoff Valve

Pipe Clamp

Advertising