Horizon Fitness CLUB SERIES CSE 3.5 - Manual (Page 6)

BEFORE
YOU
BEGIN
10
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
11
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
���������������������
��������������
����������������������
����������
����������
���������
ASSEMBLY STEP 3
A) Open HARDWARE BAG FOR STEP 3.
B) Attach the PERIMETER BARS using 4 BOLTS (E).
C) Attach REAR STABILIZER COVER using 2 SCREWS (F).
D) Attach FRONT STABILIZER COVERS using 2 SCREWS (F) for each side.
��������
�����
������ ���������
�����
������
HARDWARE BAG FOR STEP 3 CONTENTS :
ASSEMBLY STEP 4
������������
���������������
������������
�������������
���������������
������������
����������
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Remove PRE-ATTACHED BOLTS & WASHERS from CONSOLE MAST.
B) Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLTS & WASHERS.
C) Attach UPPER HANDLEBARS to LOWER HANDLEBARS using PRE-ATTACHED SET SCREWS.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
WARNING
CSE3.5-4.5 Elliptical Rev 0.4.indd 10-11 6/3/05 5:42:08 PM