HONDA Accord xl 2007 Fit - Manual (Page 200)

Install the new blade onto the
blade assembly:
Pull back either end of the blade
assembly.
Place the side of the blade not
labeled ‘‘LOCK’’ on the end of
the blade assembly, and slide
the blade onto the assembly
until it is fully installed.
Slide the wiper blade assembly
onto the wiper arm. Make sure it
locks in place.
Make sure the blade is completely
installed and that its edge is not
bunched up.
Lower the wiper arm down against
the windshield, the passenger’s
side first, then the driver’s side.
To replace the rear wiper blade:
Raise the wiper arm off the glass.
Slide the blade out of the wiper
arm.
Examine the new wiper blade. If it
has no plastic or metal
reinforcement along the back
edge, remove the metal
reinforcement strips from the old
wiper blade and install them in the
slots along the edge of the new
blade.
Slide the new blade into the wiper
arm. Make sure it is engaged in
the slot along its full length.
Lower the wiper arm.
2.
3.
1.
4.
5.
6.
7.
8.
5.
Wiper Blades
196
BLADE
REINFORCEMENT