Hitachi 53SBX01B - Manual (Page 37)

PICTURE-IN-PICTURE (PIP)
37
(1) PIP button
Press the PIP button and a sub-picture will appear in one of the three different modes
(SINGLE, SPLIT or SURF), depending on the last selection of the PIP mode. To change the
PIP mode use the THUMB STICK
or and the new selection will appear the next time
the PIP function is used.
SINGLE MODE PIP
Press the PIP button and a sub-picture appears in one corner of the screen. Press the button
again to reduce the size of the sub-picture. Use the PIP button a third time to remove the sub-
picture from the screen. Press the INPUT button when sub-picture channel tuning is
controlled, to change between VIDEO: 1, VIDEO: 2, VIDEO: 3 and ANT A antenna source.
(ANT B source cannot be viewed as a sub-picture and COMPONENT VIDEO: Y-CB-CR
INPUT 2 source will be displayed as a blank sub-picture).
SPLIT MODE PIP
When you press the "PIP" button, the main channel and the PIP sub-picture will appear at the
center of the screen (main channel on left side and sub-picture on right side). Press the "PIP"
button a second time to return t normal viewing. Use the PIP CH button to select between
man and sub-picture tuning control (indicated by highlighted channel display). Press the
INPUT button when sub-picture channel tuning is being controlled, to change between VIDEO:
1, VIDEO: 2, VIDEO: 3, and ANT A antenna source. (ANT B source cannot be viewed as a
sub-picture and COMPONENT VIDEO: Y-CB-CR INPUT 2 source will be displayed as a blank
sub-picture).