Husqvarna 968999211 - Manual (Page 11)

11
3
CONTAINER ASSEMBLY
(See Figure 3)
1. Place bottom half inside of top half, as shown.
2. Place one foot inside bottom half and lift top
half to meet bottom half.
3. Press halves tightly together while lifting top
to lock into place as shown.
IMPORTANT: BEFORE LOCKING THE TABS,
HOOKED EDGES ON BOTH HALVES MUST
OVERLAP TO FORM SEAL AS SHOWN IN IN-
SET.
FIGURE 3
ASSEMBLY
ASSEMBLY CHECK: Squeeze sides of lower half
of container and check that there is no gap be-
tween upper and lower halves. If a gap appears,
unlock tabs to separate container halves and re-
peat instructions above.
4
CONTAINER MOUNTING
(See Figure 4)
1. Install one container to left side first with
warning to the outside of unit. Install another
container to center position and one in right
position.
NOTE: Right container should always overlap left
container at center supports.
2. Close cover and lock latch handles over
center support tubes.
FIGURE 4
WARNING
DO NOT operate mower unless container
is properly installed. Container is subject
to wear and deterioration, check contain-
ers frequently, replace when cracked or
damaged. Use only a recommended re-
placement container.
CONTAINER
BOTTOM
HALF
CONTAINER
TOP HALF
CONTAINER
BOTTOM
HALF
PRESS TOGETHER
TO FORM SEAL
WHILE LIFTING
TOP HALF
LOCKING
TAB
COVER LATCH
HANDLES
CONTAINER
WARNING
CENTER
SUPPORT
TUBES
CONTAINER
HANDLE
CONTAINER
WARNING