Hyster P2.0SE - Manual (Page 4)

NOTE:
The condition of the vehicle and how it
is equipped, as well as the nature and
condition of the operating area affect
specifications. If these specifications are
critical, the proposed application should
be discussed with your dealer.
Value or text in brackets are referred
to a truck equipped with fixed side (Biga) or
fixed back (Bob) protections.
‹ Values are referred to a P2.0S
equipped with Servo Power Steering
and battery compartment of 400 Ah
(300 Ah for P2.0S) with Fork b
5
= 560
L = 1183
™ Speed with electric Servo Power
steering. For higher speed (12,5 km/h)
applications consult your TM - TC
z Values determined by wheel friction,
if climbing ramps frequently (within 1 h),
consult your salesman
„ With mechanical steering 6/6 km/h
cause truck is without side gates, With
Optional fixed or foldable Side
protection 7,4/7,5 km/h
S More forks dimensions see the table
{ Add 61 mm with fixed side
protection (Biga)
Add 110 mm with fixed back
protection (Bob)
† Add 75 mm with fixed side
protection (Biga)
Add with 114 mm fixed back
protection (Bob)
Ë 10/15 with fixed side protection (Biga),
10/14 with fixed back protection (Bob)
Notice
Care must be exercised when handling
elevated loads. When the carriage
and/or load is elevated, truck stability
is reduced. It is important that mast tilt
in either direction be kept to a
minimum when loads are elevated.
Operators must be trained and adhere
to the instructions contained in the
Operating Manual.
Safety:
This truck conforms to the current EU requirements.
Hyster products are subject to change without notice.
Lift trucks illustrated may feature optional equipment.
Ast = W
a
+ x + l
6
+ a (see lines 4.33 & 4.34)
a = Minimum operating clearance
(V.D.I. standard = 200 mm BITA recommendation = 300 mm)
l
6
= Load length