2 connecting to a netware 4.11 server – HP 04H8095 User Manual
Page 7
2 Connecting to a Netware 4.11 Server
Windows for Workgroups
2 Connecting to a Netware 4.11 Server
Windows for
Workgroups
Requirements
•
HP Vectra with DOS and MS-Windows for Workgroups 3.11 installed.
•
IBM LANStreamer 16/4 PCI TR adapter and drivers diskettes ver 1.01.
•
Driver Name: IBMMPC.DOS Size: 59KB Date: 5/22/95
•
Novell Netware 4.11 server that supports Net BEUI, NWLink IPX/SPX,
and NWLink NetBIOS transfer protocols.
•
Netware client for DOS and MS-Windows.
Device Configuration
•
Interrupt
9 (2)
•
I/O Address
FCC0-h
Procedure
1 With the HP Vectra turned off install the IBM LANStreamer 16/4 PCI TR
adapter card into a PCI slot.
2 Insert the IBM LANStreamer TR drivers disk 1 of 6 (AUTO LANStreamer
PCI Diagnostic Disk) and power on the machine.
3 After the machine boots, verify that the adapter finished testing and that
the adapter is “OK.”
4 Click on “F3” to exit, and then press “CTRL+ALT+DEL.”
5 Boot the machine to a DOS prompt, and Netware client for DOS and MS-
Windows disk 1.
6 Execute INSTALL.EXE and set lines 1-5 as listed below;
•
C:\NWCLIENT
•
YES
•
YES
C:\WINDOWS
•
NO