HP PhotoSmart A620 Series - Manual (Page 37)

Remove red-eye from your photos
The printer provides a way to reduce red-eye that can occur in photos taken with a flash.
To remove red-eye
1. Touch Edit Photo when viewing a photo with red-eye in 1-up view.
2. Touch Remove Red-Eye.
The Red-eye icon flashes and then displays continuously after red-eye removal.
A message is displayed If the printer does not detect red-eye in the photo.
3. To undo red-eye removal, touch Edit Photo when viewing the photo with red-eye
removed and then touch Undo Red-Eye.
Adjust photo brightness
To adjust photo brightness
1. Touch Edit Photo when viewing a photo in 1-up view.
2. Touch Photo Brightness.
3. Touch the arrows to adjust to the desired brightness and then touch Done.
Change print quality
You can set the printer to print photos at a higher or lower level of quality. The default
print quality is determined by the paper type setting. The default print quality setting
produces the highest quality photos, but is also a slightly slower print mode. If you want
to print a photo quickly, and are not concerned with obtaining the highest quality, choose
a lower print quality setting.
To change the print quality setting
1. Touch the Menu icon on the quick touch frame, and then touch Preferences.
2. Touch Print Quality.
3. Select a print quality:
• Best
• Normal
• Fast Normal
4. Touch OK.
This print quality setting remains in effect until you change the paper type setting or
change the print quality setting. For information on changing the paper type, see
“Load
your paper” on page 19 .
Chapter 4
36 Print without a computer