hussmann CR3HTO-HTB - Manual (Page 8)

IGFC-CR3H-HTB-1104
8
* If practical, the food should be covered during slack
sale periods to reduce dehydration.
* At end of the day, remove product and let case cool.
Then clean with soap and water (use oven cleaner
on the difficult spots). Polish and clean glass with a
good glass cleaner.
Case Startup
CONTROLS
The controls are located at the rear of the case.
Control Panel
Locaton
Timer Panel
Locaton
Parts of the case exterior, shelves and
light bulbs become extremely hot when
in use.
USE EXTREME CAUTION!
FRONT GRIDDLE
INITIAL
SETTING
"4"
REAR GRIDDLE
INITIAL
SETTING
"4"
LIGHTS and GRIDDLE ON / OFF
TURN
SWITCHES
ON
Check to make sure all lights come on
at start-up.
If they do not contact your Service
Department
Control Panel on Rear of Case
Number of controls may vary.
POWER
ON / OFF
430-01-0365 9810
1
2
3
4
5 6
7
8
9
10
Sta
rt
u
p
430-01-0365 9810
1
2
3
4
5 6
7
8
9
10
Sta
rt
u
p
Temperature Adjustment
Allow case preheat for 45 minutes prior to
loading NOTE: This equipment is
not designed to heat-up or cook food.
Food should be slightly higher temperature
than desired holding temperature
when put in display.
1. Measure PRODUCT temperature hourly by inserting a food thermometer into the food. Proper holding
temperature is 135º.
2. To change temperature, increase or decrease Overhead Heat by one number at a time. Adjust the griddle tempera-
ture as necessary. Measure product temperature again in one hour. Readjust if necessary.