Replacing the battery – HP t5135 User Manual
Page 18
Replacing the battery
Before beginning the replacement process, review
General hardware installation sequence
for
procedures you should follow before and after installing or replacing hardware.
To replace the battery:
1.
Remove the side access panel and metal side cover
2.
Remove and replace the battery
3.
Replace the metal side cover and side access panel
Removing the side access panel and metal side cover
WARNING!
Before removing the side access panel, ensure that the thin client is turned off and
the power cord is disconnected from the electrical outlet.
To remove the access panel:
1.
Remove the secure compartment cover (1). For more information, see
2.
Remove the two back panel screws that secure the access panel to the chassis (2).
3.
Slide the access panel about 1/4–inch toward the front of the unit, and then lift the access panel
up and off the unit (3).
Figure 2-4
Removing the side access panel
To remove the metal side cover:
1.
Remove the three screws that secure the metal side cover to the chassis (1).
12
Chapter 2 Hardware changes
ENWW