HONDA 08B26-S5T-1000-91 User Manual
Page 2
2 of 14
AII 27936 (0408)
©
2004 American Honda Motor Co., Inc - All Rights Reserved.
Lower.
TABS (2)
GLOVE BOX
STOPS (2)
6-Disc CD Changer (sold separately):
P/N 08A26-1B1-100
CD changer
4 Washer-screws, 4 x 6 mm
(Not used)
Adhesive seal sheet
Cover plates
CD magazine
Owner’s Manual
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Flat-tip screwdriver
Shop towel
10 mm Combination wrench
Stubby Phillips screwdriver
Diagonal cutters
Utility knife
Safety goggles
Pushpin
Drill
3 mm, 7.5 mm, and 10 mm Drill bits
Uni-bit 30 mm
Awl
Masking tape
Electrical tape or drill stop
Isopropyl alcohol
AUDIO UNIT
BUS CABLE
CD
CHANGER
Illustration of the CD Changer Installed in the Vehicle
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures should
not be attempted by “do-it-yourselfers.”
1.
Make sure you have the anti-theft code for the
radio, then write down the radio station presets.
2.
Disconnect the negative cable from the battery.
3.
Open the glove box. Lower the glove box by
releasing the right and left glove box stops.
L
R