HONDA L14-20R - Manual (Page 3)

3
INSTALLATION INSTRUCTIONS
1. Determine where you want
your EmerGen Switch located,
either to the left or right of the
load center. The switch should
be approximately 18” from the
center of the load center,
making sure that there is plenty
of room to properly connect the
flex conduit whip.
2. TURN OFF POWER. The main circuit breaker in your load center should be
switched to the OFF position. CAUTION—this does not affect the wires on the
line side of the main breaker—they will remain live! Remove the cover of the load
center.
3. Identify 3/4'' knockout to remove.
4. Insert the wires from the flex
conduit up through the
knockout; take care not to nick
or gouge the wires on the metal
edge. Tighten the locknut
securely onto the load center.
The wires can hang freely.
5. Without over-manipulating the flex conduit, secure your EmerGen Switch to the
wall with fasteners appropriate for the wall’s construction. If you are mounting
this unit flush to the wall, follow instructions included with the Flush Cover Kit.