Assembly – Husqvarna 128LDX User Manual
Page 9
English---9
545196777 Rev. 2 4/30/09
ASSEMBLY
S
Push the attachment into the coupling until
the attachment snaps into place.
S
Before using the unit, tighten the knob se-
curely.
NOTE:
Make sure unit is assembled cor-
rectly as shown in this manual.
Fitting the loop handle
S
Clip the loop handle onto the shaft. Note
that the loop handle must be fitted be-
tween the arrows on the shaft.
S
Slide the spacer into the slot in the loop
handle.
S
Fit the nut, knob and screw.
S
Make a final adjustment of the loop
handle to a comfortable working position.
Tighten the knob (do not overtighten).
Assembling and dismantling
the two--piece shaft
Assembly:
S
Loosen the coupling by turning the knob.
S
Align the tab of the attachment (A) with
the arrow on the coupling (B).
B
A
Dismantling:
S
Loosen the coupling by turning the knob
(at least three times).
S
Push and hold the button (C). While
securely holding the engine end, pull the
attachment straight out of the coupling.
C
ENGINE