Harbor Freight Tools Drillmaster 6" Cut-Off Saw 69438 - Manual (Page 8)

Page 8 For technical questions, please call 1-800-444-3353. Item 69438
Figure C
Clamp Knob
Quick Release
Flip open
Angle Guide
Two Locations
Bolt
The Clamp and Angle Guide are used together to hold the workpiece securely in place.
The Angle Guide can be adjusted from 0 to 45 ° for straight or angled cuts. Adjust the
Angle Guide first, then secure the workpiece in place with the Clamp.
1. To adjust the Angle Guide:
a. Loosen both Bolts.
b. Turn the Angle Guide to the desired angle.
c. Retighten the bolts.
note: The Angle Guide can be positioned
in either pair of holes in the Base.
2. To secure a workpiece in the Clamp:
a. Turn the Handle counterclockwise a quarter turn.
b. Flip up the Quick Release.
c. Slide the clamp out as far as needed.
d. Position the work piece against the angle Guide.
e. Flip the Quick Release down
onto the Clamp threads.
f. Push the Clamp against the workpiece.
g. Tighten the Handle clockwise to
secure the workpiece.
Sa
Fet
Y
Ope
R
ati
O
n
m
aintenan
C
e
Setup