Technical data – Husqvarna 435 User Manual
Page 31
31 – English
TECHNICAL DATA
1153135-95 Rev.1 2009-12-29
Technical data
Recommended original and replacement bar and chain combinations
Following is a list of recommended cutting equipment for the Husqvarna chain saw models 435, 435e and 440e. The
combinations of power head, bar and chain have been tested and found to be in accordance with the kickback and
vibration requirements of ANSI B175.1–2000.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose
radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar.
435
435e
440e
Motor
Cylinder displacement, cu.in/cm
3
2,49/40,9
2,49/40,9
2,49/40,9
Cylinder bore, inch/mm
41
1,61/41
1,61/41
Stroke, inch/mm
1,22/31
1,22/31
1,22/31
Idle speed, rpm
2900
2900
2900
Power, kW/hp @ rpm
1,6/2,2 @ 9000
1,6/2,2 @ 9000
1,8/2,4 @ 9000
Ignition system
Spark plug
NGK BPMR 7A/
Champion RCJ 7Y/
Husqvarna PR 17Y
NGK BPMR 7A/
Champion RCJ 7Y/
Husqvarna PR 17Y
NGK BPMR 7A/
Champion RCJ 7Y/
Husqvarna PR 17Y
Electrode gap, inch/mm
0,02/0,5
0,02/0,5
0,02/0,5
Fuel and lubrication system
Fuel tank capacity, US pint/litre
0,78/0,37
0,78/0,37
0,78/0,37
Oil pump capacity at 9,000 rpm, ml/min
13
13
13
Oil tank capacity, US pint/litre
0,53/0,25
0,53/0,25
0,53/0,25
Type of oil pump
Not adjustable
Not adjustable
Not adjustable
Weight
Chain saw without bar or chain, empty tanks, lb/kg 9,3/4,2
9,7/4,4
9,7/4,4
Chain/bar
Standard bar length, inch/cm
13"/33
13"/33
13"/33
Recommended bar lengths, inch/cm
13-18"/33-46
13-18"/33-46
13-18"/33-46
Usable cutting length, inches/cm
12-17"/31-43
12-17"/31-43
12-17"/31-43
Pitch, inch/mm
0,325/8,25
0,325/8,25
0,325/8,25
Thickness of drive links, inch/mm
0,050/1,3
0,050/1,3
0,050/1,3
Drive sprocket type/teeth
Spur/7
Spur/7
Spur/7
Chain speed at max. power, m/sec
17,3
17,3
17,3