Harman-Kardon AVR 230 - Manual (Page 23)

SYSTEM CONFIGURATION SYSTEM CONFIGURATION
SYSTEM CONFIGURATION 23 SYSTEM CONFIGURATION 23
correct channel from which the test noise should be
heard will be shown in the lower third of the video
screen and in the Lower Display Line
¯. While the
test noise is circulating, the proper channel position will
also be indicated in the Speaker/Channel Input
Indicators
ˆ by a blinking letter within the correct
channel.
To adjust the output level, press the ⁄ / ¤ Buttons
n until the desired level is shown in the display or
on-screen. Once the buttons are released, the test
noise will begin to circulate again in five seconds.
When all channels have the same output level, press
the Test Button
i again to complete the process.
NOTE: Output level adjustment is not available for the
VMAx or Surround Off modes.
Additional Input Adjustments
After one input has been adjusted for Surround mode,
digital input (if any), speaker type, and output levels,
go back to the INPUT SETUP line on the
MASTER MENU (Figure 1) and enter the set-
tings for each input that you will use. In most cases,
only the digital input and surround mode will be differ-
ent from one input to the next, while the speaker type,
crossover frequency, Night mode and output level
settings will usually be the same and may be quickly
entered by entering the same data used for the
original input.
When all settings and adjustments have been made,
press the OSD Button
v to return to normal oper-
ation of the AVR.
Once the settings outlined on the previous pages have
been made, the AVR 230 is ready for operation. While
there are some additional settings to be made, these
are best done after you have had an opportunity to lis-
ten to a variety of sources and different kinds of pro-
gram material. These advanced settings are described
on pages 30 and 31 of this manual. In addition, any
of the settings made in the initial configuration of the
unit may be changed at any time. As you add new or
different sources or speakers, or if you wish to change
a setting to better reflect your listening taste, simply
follow the instructions for changing the settings for that
parameter as shown in this section.
Having completed the setup and configuration process
for your AVR 230, you are about to experience the
finest in music and home theater listening. Enjoy!