haier hlp140e - Manual (Page 16)

Trouble Shooting
(If problems occur, please pull out the plug to check)Before calling out a Service engineer have
a quick look through the following fault list- it could have save a lot of time and trouble. If your
machine is still not working properly you should contact your nearest Service office or obtain
after sales service quickly. Please do not fix the machine by yourself.
SYMPTOM CAUSE CURE
Close the front door.
Is a garment filling occurs when the
machine is working?
Is the Temperature button Indicator
light indicating "Air Dry"?
Drum won't turn.
(The three indicator
lights of Cycle
button are on at the
same time)
Dryer won't heat.
Reset the "Temp" button till the
indicator light indicates "High"
or "Low", and the light is on.
Rinse the filter-net clear.
Is the outlet filter-net been
blocked?
Dryer won't heat.
Has the Power/ ON/OFF, or
Start/Pause button been
pressed in?
No power to machine
Is the plug properly put in the
socket?
Reduce the garments amount.
Are the garments fully dehydrated?
Got the garments fully
dehydrated.
Have you dried too many garments
in weight?
Garments won't dry
enough. ( Not all the
garments are dry
enough after the
machine stops work)
Is the front door properly shut?
Have the garments got tangled up?
Separate the tangled-up
garments and make them dried.
Are the easy/hard dry clothes not
sorted? Select out the garments that
not dry to make them dried.
Select out the garments that
not dry to make them dried.
Is the dryer standing position
narrow and stuffy? Place the machine in a position
that ventilate well.
This is probably as a result of
the heat been absorbed by the
wet clothes for a while when
starting the machine, after 30
minutes it will be normal. Is the clothes dryer working?
Press in the Start/Pause
button.
You may have chosen the "Auto-Dry"
mode of drying if the garments are
not dried over 5 hours .
( Referring to symptom 3) Drum won't turn.
(The "150", " 90",
"60” indicator lights
of Drying Time
button are on at the
same time) After troubleshoot problem 3,
press in the Power/ ON/OFF,
or Start/Pause button.
Reset circuit breaker; use the
machine when there is power.
Check and tighten plug.
Close the front door.
Press in the Power/ ON/OFF,
or Start/Pause button.