Husqvarna 500CT - Manual (Page 4)

Assembly of Handguard.
1. Insert Handguard into slot as illustrated in
figure A
, ensuring that it is securely locat-
ed.
DO NOT USE THE PRODUCT WITH-
OUT FITTING THE HANDGUARD
Assembly
A
Charging the Battery
Initial Charging Procedure
1. Use the charger indoors only.
2. Ensure the charger is not exposed to mois-
ture. Keep the charger and the product dry
at all times.
3. Connect the charger cable to the Charger
Cradle
(A1)
. and plug the Charger into a
suitable household electrical wall socket and
switch on
(A2).
.
4. Place the Battery Pack into the Charger
Cradle.
(B)
.
5. The red indicator lamp glows continuously
during charging.
(B1)
6. Full charge will be achieved in 5-6 hours
During charging the charger becomes warm.
This is normal and means the charger is
operating correctly. When the Battery Pack
is fully charged, the red indicator lamp will
change to green.
7.
Connect the Battery Pack to the product by
pressing the two buttons either side of the
Battery Pack and attaching to the back of
the product.
(C)
Re-Charging Your Product
1. Re-charge the battery as soon as the cutting
power of your cordless product begins to die
and slow down.
2. Avoid running the product into "deep" dis-
charge, i.e. avoid flattening the battery com-
pletely.
3. Follow the procedure outlined in the
Initial
Charging Procedure.
4. Charging the battery according to these
instructions should ensure maximum battery
life.
A
1
2
B
1
C