Hayter Mowers RT380H - Manual (Page 10)

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
Front wheels 2
Shim washers (as required) 2
Flat washers 2
Cotter pins 2
1
Hub caps 2
Install the front wheels.
2
No parts required – Check the tyre pressure.
Steering wheel 1
3
Spirol pin 1
Install the steering wheel.
Seat 1
Knobs 2
4
Flat-washer 2
Install the seat.
Bulk electrolyte, 1.260 specific gravity
(purchase separately) As
needed
Bolt (1/4 x 3/4 inch) 2
5
Wing nut 2
Activate the battery.
6
No parts required – Check the engine oil level.
Anti-scalp wheels 2
Wheel bolt 2
7
Locknut 2
Install the anti-scalp wheels.
8
No parts required –
Preparing the cutter deck discharge
chute.
9
No parts required – Lubricate the tractor.
10
No parts required – Check the safety interlock system.
11 No parts required – Purge the hydro transaxle,
12
No parts required – Check the hydro neutral position.
13
No parts required – Check the traction control pedal.
Media and Additional Parts
Description Qty. Use
Ignition key 1 Start the engine.
Reverse interlock key 1 Enable mowing operation in reverse.
Lift assist spring removal tool 1 Save for future maintenance use.
Operator’s Manual 1 Read before operating.
Certificate of Conformance 1
Noise certificate 1
CE conformance
10