Hotpoint SY86P - Manual (Page 10)

10
How to Keep Your Oven in Shape
Before cleaning your oven, or performing maintenance, dis-
connect it from the power supply.
To extend the life of your oven, it must be cleaned
frequently, keeping in mind that:
•
Do not use steam equipment to clean the appliance.
• the enamelled or stainless steel parts should be
washed with lukewarm water without using any abra-
sive powders or corrosive substances which could ruin
them; Stainless steel could get stained. If these stains
are difficult to remove, use special products available
on the market. After cleaning, it is advisable to rinse
thoroughly and dry.
• the inside of the oven should preferably be cleaned
immediately after use, when it is still warm, with hot
water and soap; the soap should be rinsed away and
the interior dried thoroughly. Avoid using abrasive de-
tergents (for example cleaning powders, etc…) and
abrasive sponges for dishes or acids (such as
limescale-remover, etc…) as these could damage the
enamel. If the grease spots and dirt are particularly
tough to remove, use a special product for oven clean-
ing, following the instructions provided on the packet.
• if you use your oven for an extended period of time,
condensation may form. Dry it using a soft cloth.
• it is important to ensure that the seal around the oven door
opening is not damaged. Should it be damaged, please
contact your nearest After-sales Service Centre. We
recommend you avoid using the oven until it has been
repaired.
• never line the oven bottom with aluminium foil, as the
consequent accumulation of heat could compromise
the cooking and even damage the enamel.
• clean the glass door using non-abrasive products or
sponges and dry it with a soft cloth.
How to remove the oven door
For a more thorough clean, you can remove the oven
door. Proceed as follows:
•
open the door fully;
• lift up and turn the small levers situated on the two
hinges;
• grip the door on the two external sides, shut it slowly
but not completely;
• pull the door towards you, pulling it out of its seat;
Reassemble the door by following the above procedures
backwards.
Replacing the oven lamp
•
Always unplug the appliance from the mains or switch
off the main switch before all operations.
• With the aid of a narrow, flat item (such as a screwdriver
or a spoon handle, etc...), remove the glass cover.
• Unscrew the lamp and replace it with another featuring
the same characteristics:
- voltage 230/240 V
- wattage 15 W
- type E 14
• Replace the glass cover and ensure you reposition the
seal correctly.
1 3 2
1 2 3
Glass door
Seal
Lamp
Oven
compartment