Homelite MIGHTYLITE UT08981 - Manual (Page 11)

Page 11
STARTING ANd STOPPING
See Figures  - .
Starting the product differs depending on whether the engine
is cold or warm. Blower should be on a flat, bare surface
for starting.
TO START A COLd ENGINE:

Slowly press the primer bulb seven (7) times.
 Rotate the choke dial clockwise to the FULL CHOKE
position.
NOTE: Each choke position is identified by a detent in
the housing.
 Squeeze the throttle trigger fully and hold. Press trigger
lock button in and release throttle trigger.
 Pull the starter grip sharply until engine attempts to run
(no more than 4 pulls).
 Rotate the choke dial to the counterclockwise HALF
CHOKE position.
 Pull the starter grip sharply until the engine runs.
 Allow the engine to run for 10 seconds. Squeeze the
throttle trigger to release the trigger lock.
 Rotate the choke dial counterclockwise to the RUN
position.
TO START A WARM ENGINE:

Rotate the choke dial counterclockwise to the RUN
position.
 Slowly press the primer bulb seven (7) times.
 Pull the starter grip sharply until the engine runs.
TO STOP THE ENGINE:
See Figure .
Press and hold the OFF switch until the engine stops.
IF ASSISTANCE IS REqUIREd STARTING
THIS PROdUCT:
Do not return this product to the retail store where it was
purchased. Please call our Customer Service Department
for any issues you may have.
For Help Call: 1-800-242-4672
OPERATION
Fig. 7
Fig. 6
primer
buLb
fuLL
chOke
haLf
chOke
ruN
chOke
diaL
Fig. 8
switch
starter
grip