Hotpoint RGB747GER - Manual (Page 39)

I
❑
ADJUST BROIL AND OVEN BURNER AIR
adjustment shutters for the top and bottom
burners regulate the flow of air to the flames.
The air adjustment shutter for the top (broil)
burner is in the center of the rear wall of the oven.
The flames for the top (broil) burner should be
steady with approximately 1“ blue cones and should
not extend out over the edges of the burner baffle.
The shutter for the bottom (oven) burner is near
the back wall behind the storage drawer or the
kick panel (depending on the model). Remove
the drawer or panel. (See Care and Cleaning
section in this book.)
To adjust the flow of air to either burner, loosen
the Phillips head screw and rotate the shutter
toward open or closed position as needed.
To determine
if the bottom
burner
flames are
burning
properly,
remove the
oven bottom
and the
burner baffle (see below). Flames should have
approximately 1“ blue cones and, if range is
supplied with natural gas, should burn with no
yellow tipping. (With most LP gas, small yellow
tips at the end of outer cones are normal.)
Flames should not lift off burner ports. If lifting
is observed,
reduce air shutter
opening until flames are stabilized. With the
baffle in place, the flames should burn steady
and should not extend past the edges of the
burner baffle.
a\
To remove the oven bottom:
1. Remove the knurled screws holding down rear
of the oven bottom.
2. Grasp the oven bottom at finger slots on
side.
3. Lift the rear of the oven bottom enough to
clear the lip of the range frame, then pull out.
Burner Baffle —–Remove Screw
To remove the burner baffle (on some models):
1. a nut driver to remove the 1/4” hex-head
screw shown in the illustration above. Do
not remove any other screws.
Pull baffle straight out until it is free from the
slot that holds it at rear of oven.
next page)
39