Changing multiplexer components 23, Changing multiplexer components, 23, Changing, 23 – HP E1367A User Manual
Page 23: Fuses, location of, 23, Interrupt priority jumpers, 23, Logical address switch, setting of, 23, Components, changing of, 23, Logical address switch, 23, Logical address, 23, Setting of, 23
Advertising
Changing Multiplexer Components
As required, you can change the logical address switch setting, replace the
protection fuses, change the interrupt priority jumper setting, or remove
channel termination resistors. See Figure 2-5 for locations.
Figure 2-5. RF Multiplexer Component Locations
Chapter 2
Configuring the HP E1366A/E1367A RF Multiplexers 23
Advertising
This manual is related to the following products: