Huffy 211573011 - Manual (Page 8)

8 P/N 21157301 09/04
1.
5"
(13 cm)
MIDDLE
TOP
5"
(13 cm)
BOTTOM
2
3
1
Identify pole sections.
ID Sticker
ID Sticker
2.
WOOD SCRAP
(NOT SUPPLIED)
2
1
While maintaining alignment, bounce middle pole section (2) into top section (1)
using a wood scrap as shown until the top pole no longer moves toward the pole
identification sticker on the middle pole.
TROUGH
Align dimple of top pole section (1)
into trough of middle pole section (2)
as shown.
IMPORTANT!:
POLE SECTIONS
SHOULD HAVE A
3-1/2" (9 CM)
MINIMUM OVERLAP.
NOTE:
HOLE
DIMPLE
middle pole THE IDENTIFICATION STICKER IS
LOCATED 5" FROM THE END OF
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE POLE
SECTIONS SHOULD HAVE A 3-1/2"
MINIMUM OVERLAP, LEAVING 1-
1/2" BETWEEN THE OVERLAPPING
POLE AND THE IDENTIFICATION
STICKER.
CAUTION!
5"
middle pole
1-1/2"
ID
STICKER