Harbor Freight Tools 44493 - Manual (Page 5)

Page 5 SKU 44493
Charging Battery
The Battery does not come charged from the factory. Charge for 5 to 6 hours before using.
1. Plug the Charger cord into an electrical outlet.
2. Insert the battery (32) into the Charger Base. The battery can only insert one way.
4. Press the Set button to start the charging
The ON indicator light should come on. If it does not come on, check the power
connection or try a different outlet.
5. Charge the Battery for 5 to 6 hours.
Subsequent full charges should take less time. When battery is completely charged,
the Charger will automatically shut off. The ON Indicator light will turn off, and the OFF
indicator will light.
6. After charging, unplug the Charger from the wall outlet.
7. Insert the Battery into the Chainsaw.
Note: the operation time of a new battery will ramp up as it is properly used and recharged.
Inserting Battery into Unit
1. Insert Battery (32) into the receptacle at the Chainsaw handle bottom. It can only fit in
one way.
2. Secure the lock-spring clasps to each side of the handle.
Cutting Operation
1. Stand in front of the wood to be cut with your feet firmly in place.
2. Grasp the Rubber Cover (22) with your left hand.
ON Light
OFF Light
SET Button
Charger
Battery (32)
Warning: Never
charge battery more
than 12 hours
continuously. Charg-
ers should not be left
plugged in, or charg-
ing for more than 12
hours.
Rev 02d