Husqvarna 917.377231 - Manual (Page 4)

4
WARRANTY
SECTION 1: LIMITED WARRANTY
Husqvarna Forest & Garden Company (“Husqvarna”)
warrants Husqvarna product to the original purchaser
to be free from defects in material and workmanship
from the date of purchase for the “Warranty Period” of
the product as set forth below:
2 YEAR NON-COMMERCIAL WARRANTY: Auto-
matic Mower, Riding lawn mowers, yard and garden
tractors, walk behind mowers, tillers, chain saws,
trimmers, brushcutters, clearing saws, snow blowers,
handheld blowers, backpack blowers, hedge trimmers,
electrical products and power-assist collection systems
for non com mer cial, nonprofessional, noninstitutional or
nonincome producing use, except as herein stated.
Emission control system components necessary to
comply with CARB-TIER-II and EPA regulations.
Husqvarna Safety Apparel carries a 90-day warranty
from the date of the customer’s original purchase for
defects in material and workmanship. Normal wear,
tear or abuse is not covered under warranty. Product
must be returned to Charlotte with a warranty claim
form. All care and maintenance instructions must be
followed as stated by the manufacturer on the care
label. The fi t of the protective apparel/boot is not
covered under warranty.
SECTION 2: HUSQVARNA’S OBLIGATIONS UNDER
THE WARRANTY
Husqvarna will repair or replace defective components
without charge for parts or labor if a component fails
because of a defect in material or workmanship during
the warranty period.
SECTION 3: ITEMS NOT COVERED BY THIS WAR-
RANTY
The following items are not covered by this warranty:
(1)Normal customer maintenance items which become
worn through normal regular use, including, but
not limited to, belts, blades, blade adapters, bulbs,
fi lters, guide bars, lubricants, rewind springs, saw
chain, spark plugs, starter ropes and tines;
(2) Natural discoloration of material due to ultraviolet
light;
(3) Lawn and garden attachments are covered by a
third party which gives a warranty, all claims for
warranty should be sent to the manufacturer; and
(4)Emission Control System components necessary
to which are manufactured by third party engine
manufacturer.
SECTION 4: EXCEPTIONS AND LIMITATIONS
This warranty shall be inapplicable to defects resulting
from the following:
(1) Accident, abuse, misuse, negligence and neglect,
including stale fuel, dirt, abrasives, moisture, rust,
corrosion, or any adverse reaction due to incorrect
storage or use habits;
(2) Failure to operate or maintain the unit in accor-
dance with the Owner’s/Operator’s manual or
instruction sheet furnished by Husqvarna;
(3) Alterations or modifi cations that change the
intended use of the product or affects the product’s
performance, operation, safety, or durability, or
causes the product to fail to comply with any ap-
plicable laws; or:
(4) Additional damage to parts or components due to
continued use occurring after any of the above.
REPAIR OR REPLACEMENT AS PROVIDED UNDER
THIS WARRANTY IS THE EXCLUSIVE REMEDY OF
THE PUR CHAS ER. HUSQVARNA SHALL NOT BE
LIABLE FOR ANY INCIDENTAL OR CONSEQUEN-
TIAL DAMAGES FOR BREACH OF ANY EXPRESS
OR IMPLIED WARRANTY ON THESE PRODUCTS
EXCEPT TO THE EXTENT PROHIBITED BY AP-
PLICABLE LAW. ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICU-
LAR PURPOSE ON THESE PRODUCTS IS LIMITED
IN DURATION TO THE WARRANTY PERIOD AS
DEFINED IN THE LIMITED WARRANTY STATE-
MENT. HUSQVARNA RE SERVES THE RIGHT TO
CHANGE OR IMPROVE THE DESIGN OF THE
PRODUCT WITHOUT NO TICE, AND DOES NOT
ASSUME OBLIGATION TO UPDATE PREVIOUSLY
MANUFACTURED PROD UCTS.
Some states do not allow the exclusion of incidental
or consequential damages, or limitations on how long
an implied warranty lasts, so the above limitations or
exclusions may not apply to you. This warranty gives
you specifi c legal rights, and you may also have other
rights which vary from state to state.
SECTION 5: CUSTOMER RESPONSIBILITIES
The product must exhibit reasonable care, mainte-
nance, operation, storage and general upkeep as
written in the maintenance section of the Owner’s/
Operator’s manual. Should an operational problem
or failure occur, the product should not be used, but
delivered as is to an authorized Husqvarna dealer for
evaluation. Proof of purchase, as explained in section
6, rests solely with the customer.
SECTION 6: PROCEDURE TO OBTAIN WARRANTY
CONSIDERATION
It is the Owner’s and Dealer’s responsibility to make
certain that the Warranty Registration Card is properly
fi lled out and mailed to Husqvarna Forest & Garden
Company. This card should be mailed within ten (10)
days from the date of purchase in order to confi rm the
warranty and to facilitate post-sale service.
Proof of purchase must be presented to the authorized
Husqvarna dealer in order to obtain warranty service.
This proof must include date purchased, model num-
ber, serial number, and complete name and address of
the selling dealer.
To obtain the benefi t of this warranty, the product
believed to be defective must be delivered to an
authorized Husqvarna dealer in a timely manner, no
later than thirty (30) days from date of the operational
problem or failure. The product must be delivered at
the owner’s expense. Pick-up and delivery charges are
not covered by this warranty. An authorized Husqvarna
dealer can be normally located through the “Yellow
Pages” of the local telephone directory or by calling
1-800-HUSKY62 for a dealer in your area.
HUSQVARNA
7349 Statesville Road
Charlotte, NC 28269
531 83 81-23 2002
45
MODEL NUMBER XT173-0084 KOHLER 4-CYCLE ENGINE
BLOWER HOUSING & BAFFLES
KEY PART
NO. NO.
DESCRIPTION
1 25 086 167-S Screw, Pan Head, #15,
6-Lobe (Hi-Lo)
2 14 332 04-S Insert, Engine Cover
(Black)
3 14 096 27-S Cover, Engine (Black)
4 25 086 288-S Screw, Shoulder (M5)
5 14 027 03-S Housing, Blower,
with Electric Start
AIR INTAKE / FILTRATION
KEY PART
NO. NO.
DESCRIPTION
1 41 037 10-S Nameplate, Service
2 14 094 13-S Kit, Air Cleaner Base
(Primer) (Includes Key
Number 1 and Air
Cleaner Base Gasket)
3 14 123 05-S Hose, Breather
4 14 096 51-S Cover, A/C Base
(Breather Gas)
5 25 086 145-S Screw, Hex Head,
Flanged (M6)
6 14 083 01-S Element, Air Cleaner
7 14 096 09-S Kit, Air Cleaner Cover
8 M-641060-S Nut, Flanged, M6 x 1.0
OIL PAN / LUBRICATION
KEY PART
NO. NO.
DESCRIPTION
1 25 086 145-S Screw, Hex Head,
Flanged (M6)
2 14 123 13-S Tube Assembly, Oil Fill
(Includes Key Number 3)
3 14 153 03-S O-Ring, Oil Fill Tube
4 14 199 01-S Kit, Oil Pan (Includes
Key Numbers 5 and 6,
Governor Gear Assy.
and Dowel Pins)
5 14 041 06-S Gasket, Oil Pan
6 14 032 05-S Seal, Oil (PTO)
7 25 086 161-S Screw, Hex Head,
Flanged (M8)
IGNITION / ELECTRICAL
KEY PART
NO. NO.
DESCRIPTION
1 25 086 145-S Screw, Hex Head,
Flanged (M6)
2 14 584 05-S Module, Ignition
(Aluminum, Std. Ignition)
3 12 132 02-S Plug, Spark (Standard)
4 14 112 07-S Spacer
5 14 072 13-S Stud
6 14 314 01-s Guard
7 14 219 07-S Brake Assembly,
Carburetor Side
(Includes Brake Lever,
Brake Spring, Flanged
Nuts, Brake Pad,
Ground To Kill Lead,
Screw, Kill Switch,
Brake Bracket, Brake
Lever Washer and
Brake Lever Rivet)
8 14 025 02-S Flywheel (Aluminum)
9 14 157 01-S Fan, Flywheel
10 14 109 02-S Cup, Drive
11 14 100 10-S Nut, Flywheel
(with Serrations)
12 14 072 12-S Stud