Honeywell R841C-E - Manual

Honeywell
THE R841 ELECTRIC HEATING RELAY IS
USED WITH A 2-WIRE, 24V THERMOSTAT
TO PROVIDE CONTROL OF ELECTRIC
HEATING EQUIPMENT. IT IS A DIRECT-
FOLLOWING RELAY WHICH OPERATES
WITH EACH CYCLE OF THE THERMO-
STAT (4 TO 6 CYCLES PER HOUR).
❑ models are used to control one
load.
❑ is used either with one thermostat
to control two loads simultaneously, or with
two thermostats to control two independent
loads.
❑ and E models include an integral
transformer; R841 D model must be powered
from a remote 24V transformer.
❑ and D models have a 1/2 inch male
conduit bushing.
❑ The and E models are for instal-
lation on a wireway or J-box.
❑ R841 E has a 1/2 inch male conduit bushing
and includes an enclosure with a low voltage
wiring compartment.
❑ Special with 10 second minimum
timing between stages is available.
❑ Each relay switches up to a 5,000 watt load.
❑ Spst MICRO SWITCH snap switches are
actuated by ambient-compensated
strips.
❑ Leadwires are provided for both line voltage
and low voltage connections.
❑ Small size and silent operation allow instal-
lation in living area, utility room, or basement,
❑ May be mounted in any convenient position.
REV. 10-79 (.11)