Hypertec HYNEU010001 - Manual (Page 5)

Remove the entire contents of the HyperNet USB Ethernet adapter
package and verify that the following items have been included and none
have been damaged during shipment:
· HyperNet USB Ethernet Adapter
· 3.5" USB Ethernet Software driver diskette
· Installation Guide
Connecting the USB Ethernet Adapter
The USB Ethernet adapter hardware installation is a simple two-step
process:
1. Connect the USB Type A plug into the USB port on the computer.
2. Attach a UTP or STP network cable (Category 3 or 5) to the RJ-45
connector located on the other side of the adapter.
The UTP or STP network cable also needs to be connected to a suitable
10base-T compatible HUB device.
Disconnecting the USB Ethernet Adapter
When you have finished working with the USB Ethernet adapter, you
can disconnect it from the computer by pulling the Type A plug from
your computer.
Note: Upon reconnecting the USB Ethernet adapter to the computer,
allow approximately up to one minute for the system to recognise the
reconnected adapter.