Home Automation RC-80BZ - Manual (Page 13)

1 1 3 3
QUICK-REFERENCE SETUP GUIDE
This table displays each Installer Setup item with its default setting. The column labeled "CURRENT" can be
used to write down the current settings if any changes are made to the default settings.
Item Number Description Default Current
00 Address 1
01 Communication mode 1
02 System options 0
03 Display options 1
04 Calibration offset 30
05 Cool setpoint limit 51
06 Heat setpoint limit 91
07 Not used -
08 Not used -
09 Cooling anticipator 4
10 Heating anticipator 4
11 Cooling minimum on/off time 8
12 Heating minimum on/off time 8
13 Not used -
14 Clock adjust 30
15 Filter reminder 10
16 System runtime (This week) -
17 System runtime (Last week) -
WIRELESS COMMUNICATIONS WITH HAI CONTROLLER
This thermostat has been preprogrammed with energy saving settings recommended under the EPA Energy Star
program. When used with remote systems, HAI recommends that the thermostat be configured as "non-
programmable" (See Setup Item 03 - "Display Options").
HAI AUTOMATION SYSTEMS
The thermostat can communicate with an HAI automation system over a Z-Wave network. The controller can
send commands to the thermostat to change mode, cool setting, heat setting, status of fan and hold, and other
items.
ADDING A THERMOSTAT TO THE Z-WAVE NETWORK
When prompted by Z-Wave primary or inclusion controller to include the thermostat to the network, press and
release the ‘Hold’ button on the thermostat. This will include the thermostat on the Z-Wave network.
REMOVING A THERMOSTAT FROM THE Z-WAVE NETWORK
When prompted by Z-Wave primary or inclusion controller to exclude the thermostat from the network, press
and release the ‘Hold’ button on the thermostat. This will exclude the thermostat from the Z-Wave network.