HANNspree K226-10A1 - Manual (Page 55)

54
Situation Solution
No picture and sound.
• Connect the power cord properly.
• Press the POWER button on the control
panel or remote control.
• Press the SOURCE button to cycle through
connected video sources.
• Press the CH UP or CH DOWN button to
switch to other TV stations.
• Check the TV/CATV OSD settings. See
“TV/CATV” on page 42.
• Make sure all cables are connected properly.
No picture, or poor picture, sound is
OK.
• Check the antenna and cable connections.
• Adjust the brightness in the OSD menus. See
“Brightness” on page 30.
Picture is not in color.
• Adjust the saturation in the OSD menus. See
“Saturation” on page 34.
Picture is OK, no sound.
• Press the VOL UP button on the control
panel or remote control.
• Make sure the MTS option is set to Main or
Dual. See “MTS” on page 43.
One of the speakers has no sound.
• Adjust the balance in the OSD menus. See
“Balance” on page 40.
Can’t receive some TV channels using
cable TV.
• Try the Auto Program function in the OSD “TV
Setting” menu. See “Auto Program” on
page 44.
Want to reset TV settings. • Use the Reset function in the OSD menu.
Cannot operate menus.
• If OSD items are colored light blue, the sys-
tem is in a state such that those settings are
not available. For example, video setting is
available in TV mode.
No image but have sound.
• Make sure the video signal cable is con-
nected properly.
Troubleshooting
13