HydroSurge 400A-60 - Manual (Page 4)

Copyright 2007 - Morse Mfg. Co., Inc. Form PL400-60 (0604-____) (Updated 10/2007) Page 4
WARNING - Watch Out for Pinch Points
Stay clear of moving parts. Operator should remain behind the push handle during the lift operation.
Floor Lock
The screw-down floor lock is located on the base of the tower
(figure 3.1). Turning the floor lock clockwise until it locks in the
down position activates the floor lock. When the floor lock is
activated it prevents unwanted free wheeling of the unit. Floor
conditions determine the effectiveness of the floor lock. The
operator should verify its holding action before depending on it
to hold.
Drum Holder Assembly
The drum holder assembly (or “saddle assembly”) is the
component on the Hydra-Lift Karrier that is intended to hold the
drum. The drum holder assembly is designed to secure a
standard ribbed 55-gallon steel drum around it’s middle using a
cinch chain and ratchet tightening system. The drum holder
accepts accessories for handling smaller diameter drums.
Operator’s Manual for Morse Hydra-Lift Drum Karrier Model 400A-60
Serial Number 0604 to ____ (MMYY)
Figure 3.1
The Specialist In Drum Handling Equipment
MODEL 400A-60
Hydra-Lift, 60”, Manual Lift, Manual Tilt