Homelite UT42799 - Manual (Page 9)

Page 9
ASSEMBLY
UNPACKING
This product requires assembly.

Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-242-4672 for assistance.
PACKING LIST
Blower
Upper Tube
Lower Tube
Screw
Operator’s Manual
WARNING:
If any parts are missing do not operate this tool until the
missing parts are replaced. Failure to do so could result
in possible serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly is com-
plete. Failure to comply could result in accidental starting
and possible serious personal injury.
ASSEMBLING THE BLOWER TUBES
See Figure 2.

With the ridged area facing up, slide the upper blower
tube over the outlet on the blower housing.
 Press down on the ridged area on the upper blower tube
and continue to slide the tube forward until the screw hole
on the side of the blower tube aligns with the hole on the
blower housing.
 Install the screw provided and rotate clockwise to
secure.
 Install the lower blower tube onto the end of the upper
blower tube. Slide forward until the notched areas on the
upper tube click into the slots on the lower tube.
 Install the screw provided into the screw hole on the upper
blower tube and tighten securely in a clockwise direction
using a Phillips screwdriver.
Fig. 2
UPPER
TUBE
LOWER
TUBE
RIDGED
AREA
AIR
OUTLET
SCREW
NOTCHED
AREA
SLOT
SCREW
HOLE