Hotpoint KITCHEN THINK BS 1400 - Manual (Page 11)

9
GB
Function Effect Comments
Enabled with
programmes:
Super
Wash
Allows for an impeccable
wash, visibly whiter than a
standard Class A wash.
A, B, C, D, E, F, K
Mini
Load
Reduces water and
energy consumption and
wash cycle times.
Use this function when the laundry that needs to be
washed is equal to or less than half the recommended
max. load (see Programme table).
Reduce the amount of detergent accordingly.
A, B, C, D, E, F, H,
K, L, M, Rinse
cycle.
Easy
Iron
This option reduces the
amount of creasing on
fabrics, making them
easier to iron.
If you set this option, programmes E, F, J, L, M will be
suspended, leaving the laundry to soak (Anti-crease)
and EASY IRON button will flash:
- to conclude the cycle, press the START/CANCEL
button or the EASY IRON button;
- to run the draining cycle alone, set the knob to the
relative symbol and press the START/CANCEL button.
C, D, E, F, J, K, L, M,
Rinse cycle.
Personalisations
Setting the spin cycle
If, when the appliance is switched on, the KNOB is positioned
on a programme with a spin cycle, a fixed appears. Press
button and the maximum spin speed allowed for the
programme set will be displayed, and the icon flashes.
Press it again and the values lower until they reach OFF, which
indicates that the spin cycle has been excluded (press it again
to go back to the maximum value); stop on the desired speed,
after approximately 2 seconds the setting is accepted: the
symbol remains fixed. The spin cycle setting is enabled
with all the programmes except for J and the Draining cycle.
Setting the temperature
If, when the appliance is switched on, the KNOB is positioned on a programme for which the temperature
needs to be regulated, a fixed appears. Press button and the maximum temperature allowed for the
programme set will be displayed and the icon flashes. Press it again and the temperature lowers until it
reaches OFF, which indicates a cold wash cycle (press it again to go back to the maximum value); stop on
the desired value, after approximately 2 seconds the setting is accepted: the symbol remains fixed.
The temperature adjustment is enabled with all wash programmes.
Setting the Delay Start
Press the button and you will see the word OFF on the display, while the relative symbol flashes.
Press the button again and "1h" appears, that is, a delay of one hour (this can reach up to 24h); stop on the
"desired" delay; after approximately 2 seconds the setting is accepted, following which, the time for the
set programme appears on the display and the symbol remains on.
If you now press the START/CANCEL button, the set "delay" appears; this decreases every hour until the
start of the cycle. In this phase, the "delay" can only be modified by decreasing it.
The Delay Start regulation is enabled with all programmes.
For safety reasons (for example: preventing children from climbing into the drum and locking themselves
in), if the door is opened or closed before the effective start of the cycle, it will be necessary to press the
START/CANCEL button again.
Keyboard Lock
(see page 7).
Functions
To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set.
If you set a function that is incompatible with another function you selected previously, only the last one selected will be enabled.
Option buttons
Service
Troubleshooting
Precautions
Care
Programmes
Detergents
Installation
Description