Husqvarna 13 Bio - Manual (Page 37)

36
– English
Lubrication of belt tensioner
The belt tensioner must be lubricated regularly with
high-quality molybdenum sulphide grease*.
Inject grease into the nipple on the right side below
the engine bottom pulley until grease is forced out.
With daily use lubrication should be conducted
twice a week.
LUBRICATION
Check the transmission’s oil level
Rider 13 and Rider 13 Bio
1. Lift off the transmission cover. Release the two
screws (one of each side) and lift off the trans-
mission cover.
2. Check that there is oil in the transmission oil
tank. Top up if necessary with engine oil SAE
10W/30 (class SF–CC).
General lubrication
All joints and bearings are lubricated on manufac-
ture with molybdenum sulphide grease. Re-grease
with same type of grease*. Lubricate the steering
and control wires with engine oil.
The machine should be lubricated regularly, and
twice a week when used daily.
* Grease from well-known brand names (petrol
companies, etc.) usually maintains a good quality.
The most important property is that the grease
provides good protection against corrosion.