Husqvarna 927SB - Manual (Page 31)

31
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm
IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.
Failure to do so could be hazardous, damage your snow thrower and void your warranty.
KEY PART
NO. NO. DESCRIPTION
REPAIR PARTS DRIVE
SNOW THROWER - MODEL NO. 927SB 927SB (96193004400), PRODUCT NO. 961 93 00-44
1 817 49 05-08 BOLT 5/16−18 X .500
2 532 75 11-53 NUT 5/16−18
3 532 18 00-17 FLANGE BEARING
4 873 93 05-00 NUT 5/16−18
5 532 19 95-09 RUBBER WHEEL PLATE
6 532 17 98-31 RUBBER WHEEL RING
7 532 17 86-13 RUBBER WHEEL HUB
8 874 76 05-14 BOLT 5/16−18 X .875
9 532 17 53-44 TRUNNION BEARING ASSEMBLY
10 812 00 00-12 RETAINER
11 532 18 00-66 HEX SHAFT
12 532 18 00-65 PINION GEAR
13 532 19 29-07 AUXILIARY PLATE
14 532 17 92-70 SPACER PLATE
15 532 18 00-82 INTERMEDIATE GEAR
16 532 18 01-34 AUXILIARY SHAFT
17 532 40 54-85 CONTROL ARM
18 532 05 70-79 WASHER
19 532 40 61-09 CONTROL SHAFT ASSEMBLY
20 532 19 85-80 CLEVIS PIN
21 532 18 40-80 SHIFTER LEVER
22 532 18 78-57 PIVOT BRACKET
23 532 17 88-07 PIVOT PIN
24 532 18 01-35 SPRING
25 532 18 71-01 SHIFTER LINK
26 532 08 51-79 RETAINER
27 532 70 02-79 CLIP
28 532 15 00-78 BOLT 5/16−18 x .750