Harbor Freight Tools Pittsburgh Laser Range Finder 67802 - Manual (Page 7)

Page 7 For technical questions, please call 1‑800‑444‑3353. SKU 67802
Memory
Note: Memory can be used for
distance, area, or volume
measurements.
1. Press MEM INPUT to store
displayed Total Result in memory.
If only a Current Result is
displayed, it will be stored instead.
MEM will appear on Display.
2. Press MEM RECALL later to
display stored memory and clear it.
MEM will disappear from Display.
3. MEM RECALL can be used in
steps 1 or 3 of “Addition” instead
of taking new measurements.
Area/Volume
Calculation
Note: Area/volume calculation
cannot be exited before
calculation is complete.
1. Press button to enter
area calculation mode or
press button to enter
volume calculation mode.
2. The L will blink.
Take measurement for
length as explained under
“Distance Measurement”.
3. Then, the W will blink.
Take measurement for
width as explained under
“Distance Measurement”.
4. For area calculation, the H
will blink. Take measurement
for height as explained under
“Distance Measurement”.
5. The area/volume is displayed
as Total Result at the
bottom of the display.
6. The Current Result will display
the last measurement taken.
Press READ briefly to cycle
through the measurements taken.
7. Press or button to take
another area or volume calculation.
8. Press and hold READ button
for a few seconds to exit
area/volume calculation.