HONDA Outboard Motor BF150A - Manual (Page 76)

2.5 lbf·ft (3.4 N·m , 0.35 kgf·m)
74
SERVICING YOUR OUTBOARD MOTOR
STRAINER
BRACKET
ALIGNMENT
POSITION
STRAINER
CUP
SUSPENSION
STRAP
STRAINER BODY
STRAINER CUP
SCREW (3)
FUEL FILTER
FUEL STRAINER ASSEMBLY
Remove the three screws and
separate the fuel strainer cup from
the strainer body.
Reassemble the strainer body and
the cup.
STRAINER TIGHTENING
TORQUE:
Thoroughly clean the strainer cup,
and replace the fuel filter. Align the center of suspension
strap with the screw position and
install the fuel strainer assembly.
Reinstall the strainer assembly in
the original position. 8.
7.
9. Prime the engine using the priming
bulb (refer to page ). Check for
fuel leaks. Repair any fuel leaks if
necessary.
If loss of power or hard starting are
found to be caused by excessive
water or sediment accumulation in
the fuel filter, inspect the fuel tank.
Clean the fuel tank and tank filter if
necessary. It may be necessary to
drain the fuel tank completely and
refill with fresh gasoline.
4.
5.
6.
37
05/02/22 14:36:32 31ZY6600_075